Plan to install the first switch module in bay 1, the second in bay 2, and so on up to bay 8, if possible. Identify the bays in which you will insert the switch modules.Fill any empty interconnect bays or any empty power module bays in the blade enclosure with blanks.
Review the "Safety Warnings" section and the Regulatory Compliance and Safety Information for the Cisco Catalyst Blade Switch 3000 Series for HP that accompanies this guide.Ĭonsider these prerequisites before installing your switch module:.Review and become familiar with the safety and handling guidelines specified in the blade enclosure Product Information Guide.Statement 1074īefore you install the switch module in the blade enclosure, read these guidelines: Warning Installation of the equipment must comply with local and national electrical codes. Warning For connections outside the building where the equipment is installed, the following ports must be connected through an approved network termination unit with integral circuit protection. Warning Ultimate disposal of this product should be handled according to all national laws and regulations. Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Warning Read the installation instructions before connecting the system to the power source. Warning Do not work on the system or connect or disconnect cables during periods of lightning activity. Warning Ethernet cables must be shielded when used in a central office environment. Metal objects will heat up when connected to power and ground and can cause serious burns or weld the metal object to the terminals. Warning Before working on equipment that is connected to power lines, remove jewelry (including rings, necklaces, and watches). To prevent airflow restriction, allow at least 3 inches (7.6 cm) of clearance around the ventilation openings. Warning To prevent the switch from overheating, do not operate it in an area that exceeds the maximum recommended ambient temperature of 113☏ (45☌). The EMC regulatory statements are also included in that guide. These safety warnings are translated into several languages in the Regulatory Compliance and Safety Information for the Cisco Catalyst Blade Switch 3000 Series for HP that ships with the product.
This chapter also describes how to interpret the power-on self-test (POST) that ensures proper operation and how to make connections to the switch module. The switch module is installed in one of the enclosure I/O module bays on the rear panel of the server enclosure. The HP c-Class BladeSystem, referred to as the blade enclosure, is a system that supports up to 16 server modules and up to 8 Ethernet switch modules. This chapter provides instructions on how to install your Cisco Catalyst Blade Switch 3120 for HP, also referred to as the switch module, in the HP c-Class BladeSystem enclosure and how to set up and configure your switch module.